











Regulator – HRR
£115.00
Air and CO2 pressure regulator used for adjusting fps in Mancraft AEG and Sping kits.
Based on classic and well tested design of larger Mancraft Regualtor. Small size of the device minimize its footprint and allows tank to be hold in smaller pouches. Regulation screw accessible through hole in the front of the regulator . Instead of large tournament lock there is an option to secure pressure regulation with tournament cable tie which has unique, individual serial number on each tie (also available on our website). Regulation in range of 4-17bar (60-250psi).
Size: Diameter 25mm, Length 80mm
Fitting guide:
US – the most common quick detach connector on the market. It has build in air cut-off system, so you are able to disconnect your rifle from the tank without turning down the air pressure regulator. Used in pair with HPA Lines
Micro – Mancraft alternative to US quick detach connector. Much smaller and lighter which makes it very popular among snipers. Used in pair with Micro HPA Lines
4mm / 6mm – Classic push in fitting. Does NOT have build in air cut-off system, so you can NOT disconnect your rifle from the tank without turning down air pressure regulator. Can be connected directly to the Mancraft Kit, without need of special connectors or HPA Lines. 4mm is a standard for spring kits, while 6mm is used on AEG engines where bigger air flow is preferable.
Note: Picture taken with the 4mm fitting. Depending on the selection of the fitting type, a new one may be installed in its place.